Axess Ready CM-1115-RT-AR Instalační příručka Strana 4

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 31
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 3
CM-1115(20)-RT-AR User Manual
Page 3
I. Introduction
The SurgeX
®
CM-1115(20)-RT-AR is a network attached, IP addressed, web controlled AC surge
eliminator and power conditioner. The CM-1115(20)-RT-AR may be used to switch up to 15A/20A
at 120V. The simple web server structure allows basic control of two outlets. The extensive
programming and setup capabilities are accessed by a web browser, through a Device
Management Utility (DMU), or through a Command Line Interface (CLI).
The CM-1115(20)-RT-AR features SurgeX
®
Advanced Series Mode
®
surge elimination,
Impedance Tolerant EMI/RFI filtering, SurgeX ICE
®
Inrush Current Elimination, SurgeX
®
CouVs
®
Catastrophic Over/Under-Voltage Shutdown, and low level control inputs/outputs.
Remote reboot any device: monitors, routers, servers, kiosks, etc. The remote device need
not be network attached.
Conserve energy by powering down equipment when not in use.
Telnet access uses the Command Line Interface (CLI) structure and syntax to completely
configure and control the CM-1115(20)-RT-AR. This Axess Ready (AR) device also
supports the DxP protocol, which allows software developers to integrate the unit into
custom applications.
Up to 2 systems can be continuously monitored with AutoPing, with automatic power
control upon loss of contact. Reboot crashed systems, or provide auto power-up or -down
for environmental controls and notification systems.
The CM-1115(20)-RT-AR utilizes 2 levels of password security, with only the
administrative account having access to setup and configuration.
Accepts both DC voltage and contact closure control inputs.
Two or more units can be cascaded together for larger systems.
Auxiliary relay output can be used to control other SurgeX
®
products.
12 Volt DC output can be used to control other SurgeX
®
products or drive LEDs.
Auxiliary relay or 12 Volt DC output can be used to provide confirmation feedback.
Zobrazit stránku 3
1 2 3 4 5 6 7 8 9 ... 30 31

Komentáře k této Příručce

Žádné komentáře